Input: three groups of XLR balance, three groups of RCA imbalance
Digital input: 1 set of USB audio, 1 set of S / PDIF
Output: 1 set of RCA, 1 set of XLR, 1 set of fixed tape
Frequency response: 20Hz to 20KHz ± 0.2dB
Input impedance: 1MOhm (single ended), 40kohm (balanced)
Output impedance: main output 100ohm, tape output 600ohm
Maximum gain: 16dB, 26dB switchable
Distortion: thd < 0.01% @ 20n kHz 1V input
Power consumption: 37W
It is designed with a fully balanced architecture and equipped with an electronic analog volume control circuit. Users only need to operate with their fingers on the touch button with backlight on the surface to control the volume and other functions, full of science and technology sense.
New development of the electronic analog volume control system, can eliminate the volume of the mechanical contact point, traditional resistance type acoustic technology, let the music signal without a variable resistance, make the impedance change completely unaffected by passive components, can significantly improve the signal-to-noise ratio and distortion, and made to further improve quality.
The digital volume system by adopting high precision SMT components and more advanced welding technology, the system of higher precision, around two channel consistency is admirable, and at the same time the influence of the weak distortion may be reduced, the CRESCENDO from input to output achieve full balance circuit, provide high purity signal amplifier, tone is more pure, more precise operation.
The analog amplification part adopts the fully balanced amplification technology, the positive and negative chord waves in the signal are processed separately by the four independent circuits and the amplifier circuit, the intermodulation distortion and noise are completely controlled, and the dynamic range is greatly realized, and it is less affected by the noise of the power supply, so as to improve the sound purity and reduce the problem of left and right channels interfering each other.